Air Vent - Instrument Panel - Driver (LHD) (Remove and Replace)
Correction Code: 18100032 1.08 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Remove the IP sub-assembly. See Sub Assembly - Instrument Panel (Remove and Install).
-
Disconnect the air wave ventilation
connectors (x4).
NotePosition the sub-assembly upside down on a protective surface to access the connectors.
-
Remove the screws (x5) that attach the
aero glass assembly to the instrument sub-assembly, and then release aero glass assembly
from the sub-assembly.Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
-
Rotate the aero glass assembly forward
to release the tabs (x8) that attach the assembly to the instrument panel
sub-assembly.
-
Remove the aero glass assembly from
the instrument panel sub-assembly.
-
Remove the screws (x5) that attach the
driver instrument panel air vent to the instrument panel sub-assembly.Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
Install
-
Position the driver instrument panel air vent to the instrument panel sub-assembly,
and then install the screws (x5) that attach the air vent to the sub-assembly.Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
-
Position the aero glass assembly into
the instrument panel sub-assembly.
NoteAlign the tabs (x8) from the sub-assembly to aero lens assembly.
-
Rotate the instrument panel
sub-assembly rearward to engage the tabs (x8) that attach the sub-assembly to the aero
glass assembly.
-
Install the screws (x5) that attach the aero glass assembly to the instrument
sub-assembly.Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
-
Connect the air wave ventilation connectors (x4).
NotePosition the sub-assembly upside down on a protective surface to access the connectors.
- Install the instrument panel sub-assembly and all other parts that were removed for access . See Sub Assembly - Instrument Panel (Remove and Install).