2022-06-17

Side Repeater - Front - LH (HW3) (Remove and Replace)

Correction code 17403002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Apply tape to the LH fender at the edges of the side repeater.
  2. Remove the LH repeater from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If reinstalling the same side repeater, take care not to damage the mounting tabs.
    1. Apply light, constant pressure toward the fender at the rear of the repeater, and maintain pressure until the repeater is removed.
    2. Slide the repeater toward the rear of the vehicle until the front clip releases, then pull the repeater away from the fender until the front clip is outside of the fender.
    3. Slide the repeater toward the front of the vehicle until the rear hook clip disengages from the fender.
  3. Disconnect the electrical connectors to the LH side repeater and camera.

Install

  1. Connect the electrical connectors to the LH side repeater and camera.
  2. Carefully install the LH repeater to the fender.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If reinstalling the same side repeater, make sure the mounting tabs are not damaged. If any of the tabs are damaged, replace the repeater.
    1. Insert the rear hook clip to the repeater slot in the fender and apply light constant pressure at the rear of the repeater, and maintain pressure until the repeater is installed.
    2. Slide the repeater rearward until the rear hook clip engages the fender and the front clip clears the edge of the repeater slot in the fender.
    3. Press on the front of the repeater until the front clip is inside of the repeater slot. Slide the repeater toward the front of the vehicle until the front clip engages the fender, and then release pressure on the repeater.
  3. Remove the tape from the fender.