Overslam - Liftgate - LH (Remove and Replace)
Correction code
11335202
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open the liftgate.
-
Turn the LH liftgate overslam
counterclockwise to remove it from the liftgate assembly.
Install
-
Install the LH liftgate overslam into
the the liftgate assembly.
- Close the liftgate.
-
Check for gap/flushness between
liftgate and surrounding panels.
NoteMeasure 10x points labeled in image. Refer to CVIS for current specification targets.
- Open the liftgate.
-
Adjust the liftgate overslam to
achieve flushness target.
NoteRotate the overslam clockwise to decrease bumper height or counter-clockwise to increase bumper height as required to achieve flushness target.
- Close the liftgate.