17/05/2023 08:44:23

Spoiler - Rear (Retrofit using Jig)

Correction code 12220416 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Procedure

  1. Clean the liftgate area of any debris.
    Informational PurposesAn informational icon, calling your attention
    Note
    Clean all debris and prepare the area for installation of the rear spoiler. Wipe the area with an Isopropyl Alcohol (IPA) wipe and allow the surface to dry for 1 minute.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the area requires any paint correction, request assistance from shop detailer before installation of the rear spoiler.
  2. Secure the spoiler jig special tool (1694265-00-A) onto the liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    Line up jigs with the edges of the liftgate, and then use masking tape to secure the jigs as needed.
  3. Perform a dry fit of the rear spoiler.
    Informational PurposesAn informational icon, calling your attention
    Note
    The rear spoiler should line up with reference markings on the jigs. Adjust the jigs for a centered installation of the spoiler.
  4. Peel off the adhesive tape on the rear spoiler, and then install the spoiler.
    Informational PurposesAn informational icon, calling your attention
    Note
    Carefully line up the rear spoiler to the jigs and apply pressure from the center outwards. Verify the spoiler is fully adhered to the liftgate.
  5. Remove the spoiler alignment jigs.
  6. Verify the rear spoiler is properly installed.
    Informational PurposesAn informational icon, calling your attention
    Note
    Wipe away any excess debris with an IPA wipe.
  7. Perform a configuration update. See SI-23-90-005 for more information.