13/09/2022 14:51:56

Subframe Assembly - Front (Remove and Replace)

Correction code 300103422.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Move the vehicle to a 2 post lift. See Raise Vehicle - 2 Post Lift.
  2. Remove the LH and RH front wheels. See Wheel Assembly (Remove and Install).
  3. Set the steering wheel straight ahead.
  4. Place a protector sheet onto the driver seat, and then install the steering wheel lock.
  5. Disconnect LV power. See LV Power (Disconnect and Connect).
  6. Remove the front fascia valance. See Valance - Front Fascia (Remove and Replace).
  7. Remove the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
  8. Remove the front skid plate. See Skidplate - Front (Remove and Replace).
  9. Remove the front subframe. See Subframe Assembly - Front (Remove and Install).
  10. Remove and discard the nuts (x4) that attach the front stabilizer bar to the front subframe, and then remove the stabilizer bar from the subframe.
  11. Remove the bolts (x3) that attach the steering rack to the front subframe, and then remove the rack from the subframe.
  12. With the help of an assistant, remove front subframe from the subframe lift.

Install

  1. With the help of an assistant, install the new front subframe to the subframe lift.
  2. Install the steering rack onto the front subframe, and then install the bolts (x3) that attach the rack to the subframe.
    167 Nm (123.2 lbs-ft)
  3. Install the front stabilizer bar to the front subframe, and then install new nuts (x4) to attach the stabilizer bar to the subframe.
    50 Nm (36.9 lbs-ft)
  4. Install the front subframe. See Subframe Assembly - Front (Remove and Install).
  5. Install the front skid plate. See Skidplate - Front (Remove and Replace).
  6. Install the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
  7. Install the front fascia valance. See Valance - Front Fascia (Remove and Replace).
  8. Install the LH and RH front wheels. See Wheel Assembly (Remove and Install).
  9. Connect LV power. See LV Power (Disconnect and Connect).
  10. Remove the steering wheel lock and the protector sheet from the driver seat.
  11. Remove the vehicle from the 2 post lift. See Raise Vehicle - 2 Post Lift.
  12. Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.