Seal - Inner Belt - Front Door - LH (Remove and Replace)
Correction code
11703202
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open the LH front door and lower the LH front window.
- Remove the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
- Remove the LH front door panel. See Panel - Door Trim - Front - LH (Remove and Replace).
-
Release the inner belt seal from the
LH front door.
TIpLift incrementally from side to side to release the seal.
Install
-
Install the inner belt seal to the LH
front door.
TIpPush down on the inner belt seal and make sure any overlap with the exterior belt seal is installed correctly.
- Install the LH front door panel. See Panel - Door Trim - Front - LH (Remove and Replace).
- Install the LH front door decor. See Decor - Trim - Front Door - LH (Remove and Replace).
- Close the LH front door and check gap fitment of the LH front door decor to the instrument panel decor.
- Calibrate the windows. See Window Regulator (Recalibrate).
- Confirm that the window operates correctly and without any abnormal noise.