Correction code 12070302 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

1. Remove front license plate with decorative frame from original fascia
   Note

   4x Screws,T20, 3 Nm

   

   

2. Remove painted bracket from original fascia
   Note

   3x Bolts, E10 5 Lobe, 1 Nm

   

   

3. Remove front license plate base bracket from original fascia
   Note

   Secured by adhesive tape. Gently pry away from fascia

   

   

4. Clean any remaining adhesive from fascia

   

   

5. If not already present, install new adhesive strips on the new base bracket.

   

6. Position the painted bracket on the base bracket, and then install the bolts (x3) that attach the painted bracket to the base bracket.
   Note

   3x Bolts, E10 5 Lobe, 1 Nm
   
7. Peel adhesive backing from new license plate bracket

   

8. Install license plate bracket to fascia
   Note

   Align bracket with body lines, press bracket against fascia firmly to secure adhesive

   

   

9. Install license plate with decorative frame
   Note

   4x Screws,T20, 3 Nm