2022-06-17

Deflector - Valance - Front Fascia - LH (Remove and Replace)

Correction code 10012032 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Raise and support vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the bolts that attach the front fascia valance to the vehicle.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not remove the middle bolts (x3).
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench
    • 4 in extension
  3. Remove the clips that attach the front fascia valance to the vehicle, and then release the valance from the front aero shield.
  4. Remove clips that attach the LH wheel arch liner to the valance and front fascia.
  5. Remove the nuts (x2) that attach the LH front fascia valance deflector to the valance and front fascia.
    3 Nm (2.2 lbs-ft)
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
  6. Release the tabs and studs that attach the LH front fascia valance deflector to the valance and front fascia, and then remove the deflector from the vehicle.

Install

  1. Install LH front fascia valance deflector onto the valance and front fascia.
  2. Install the nuts (x2) that attach the LH front fascia valance deflector to the valance and front fascia.
    3 Nm (2.2 lbs-ft)
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
  3. Install the clips (x3) that attach the LH wheel arch liner to the valance and front fascia.
  4. Apply Loctite 222 to the fasteners, and then install the bolts that attach the front fascia valance to the front aero shield.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Insert the valance datums into the aero shield alignment holes.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • Flex head ratchet/flex head torque wrench
    • 4 in extension
  5. Lower the vehicle and remove it from the lift. See Raise Vehicle - 2 Post Lift.