17/06/2022 13:38:08

Microphone - Headliner - Front - LH (Remove and Replace)

Correction code 15204202 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  2. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace)
  3. Remove the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  4. Remove the driver sun visor. See Sun Visor - LH (Remove and Replace).
  5. Remove the LH upper B-pillar trim. See Trim - B-Pillar - Upper - LH (Remove and Replace).
  6. Repeat step 1 through step 4 for the RH side of the vehicle.
  7. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  8. Remove the upper quad camera cover. See Upper Cover - Rear View Mirror (Remove and Replace).
  9. Release the clips (x5) that attach the front of the headliner to the vehicle.
  10. Disconnect the LH front headliner microphone electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    The harness may have little slack due to headliner adhesive.
  11. Remove the bolts (x2) that attach the LH front headliner microphone to the headliner, and then remove the microphone from the vehicle.
    0.3 Nm (3 lbs-in)
    Tip: Use of the following tool(s) is recommended:
    • T10 socket

Install

  1. Position the LH front headliner microphone into the headliner, and then install the bolts (x2) that attach the microphone to the headliner.
    0.3 Nm (3 lbs-in)
    Tip: Use of the following tool(s) is recommended:
    • T10 socket
  2. Connect the LH front headliner microphone electrical connector.
  3. Secure the clips (x5) that attach the front of the headliner to the vehicle.
  4. Install the upper quad camera cover. See Upper Cover - Rear View Mirror (Remove and Replace).
  5. Install the rear view mirror. See Mirror - Rear View (Remove and Replace).
  6. Install the passenger sun visor. See Sun Visor - LH (Remove and Replace).
  7. Install the RH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  8. Install the RH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace)
  9. Install the RH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  10. Install the LH upper B-pillar trim. See Trim - B-Pillar - Upper - LH (Remove and Replace).
  11. Repeat step 6 through step 9 for the LH side of the vehicle.
  12. Install the lower quad camera cover. See Camera Cover - Lower (Remove and Replace)