01/04/2024 14:43:36

Headlights - Adjust (Global) (Wall Method)

Correction code 17400160 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2024-04-01: Updated measurements and units.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Informational PurposesAn informational icon, calling your attention
Note
This procedure is for the Global Refresh version of this part. The procedure for the Original version of this part is here: Headlights - Adjust - NA (Wall Method).>
  1. Apply tape to wall 68.9 cm (27.1 in) from the ground.>
  2. Apply tape to floor7.62 m (25 ft) from the wall.>
  3. Park vehicle on flat level surface perpendicular to wall and align front fascia with tape on floor.
    Informational PurposesAn informational icon, calling your attention
    Note
    Choose a dark work area with low ambient lighting for best results, Ensure tire pressure is set to specification.
  4. Project a laser perpendicular to the wall onto the center point of the vehicle, then mark a center-line on the wall.
  5. Measure 78 cm (30.7 in) from center and make a mark on both sides of the center-line.
    Informational PurposesAn informational icon, calling your attention
    Note
    These reference marks will be the targets for horizontal adjustment.
  6. Open LH front door.
  7. Lower LH front window.
  8. Set air suspension ride height to “Medium”.
    Informational PurposesAn informational icon, calling your attention
    Note
    Using center display, Controls > Suspension > ''Medium", Re-select ride high setting to "Medium" to ensure leveling is complete.
  9. Enter headlight adjustment mode through center display.
    Informational PurposesAn informational icon, calling your attention
    Note
    via Controls > Service > Adjust Headlamps.
  10. Vehicle will automatically perform headlight calibration.
  11. Completely cover RH headlight.
  12. Select "Left" then use left scroll wheel on the steering wheel to adjust the beam level.
    Informational PurposesAn informational icon, calling your attention
    Note
    Adjust LH headlight so that top of horizontal beam aligns with tape mark on wall, and the left edge of the L-shaped beam aligns with LH reference tape, Do not sit in vehicle as this will affect headlamp height.
  13. Remove cover from RH headlight then completely cover LH headlight.
  14. Select "Right" then use left scroll wheel on the steering wheel to adjust the beam level.
    Informational PurposesAn informational icon, calling your attention
    Note
    Adjust RH headlight so that top of horizontal beam aligns with tape mark on wall, and the left edge of the L-shaped beam aligns with RH reference tape, Do not sit in vehicle as this will affect headlamp height.
  15. Exit headlight adjustment mode from the center display.
    Informational PurposesAn informational icon, calling your attention
    Note
    Select "X" located at top left of display.
  16. Remove cover from LH headlight.
  17. Raise LH front window.
  18. Close LH front door.