20/12/2022 10:47:22

Weldment - Pivot - Inboard - 2nd Row Seat - LH (Remove and Replace)

Correction code 13057542 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open all the doors and open all the windows.
  2. Move the driver and front passenger seats fully forward.
  3. Remove the LH and RH 2nd row seat outer bolsters. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  4. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  5. Remove the LH 2nd row seat back. See Seat Back - 2nd Row - LH (Remove and Replace).
  6. Remove the RH 2nd row seat back. See Seat Back - 2nd Row - RH (Remove and Replace).
  7. Remove the 2nd row center pivot cover.
  8. Remove the bolts (x3) that attach the LH 2nd row seat inboard pivot weldment to the body, and then remove the pivot weldment from the vehicle.
    26 Nm (19.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 11 mm deep socket
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the front of the rear trunk floor to access the top bolt and datum.

Install

  1. Position the LH 2nd row seat inboard pivot weldment into the vehicle, and then install the bolts (x3) that attach the pivot weldment to the body.
    26 Nm (19.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 11 mm deep socket
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the front of the rear trunk floor to access the top bolt and datum.
  2. Install the 2nd row center pivot cover.
  3. Install the RH 2nd row seat back. See Seat Back - 2nd Row - RH (Remove and Replace).
  4. Install the LH 2nd row seat back. See Seat Back - 2nd Row - LH (Remove and Replace).
  5. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  6. Install the LH and RH 2nd row seat outer bolsters. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  7. Restore the driver and front passenger seats back to their original position.
  8. Raise all the windows and close all the doors.