Module - HomeLink Transmitter (Remove and Replace)
Correction code
17154202
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
- Release the connector lock, and then disconnect the front underhood storage harness connector.
- Release the tab that attaches the Homelink transmitter module to the vehicle, and then remove the module from the vehicle.
Install
- Position the Homelink transmitter module into the vehicle, and then secure the tab that attaches the module to the vehicle.
- Connect the front underhood storage harness connector, and then secure the connector lock.
- Install the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
- Verify the Homelink icon is available on the vehicle touchscreen.