Map Light - LH (Remove and Replace)
Correction code
17350112
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the LH and RH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
- Remove the LH and RH sun visor. See Sun Visor - LH (Remove and Replace).
- Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
- Remove the quad camera cover. See Upper Cover - Rear View Mirror (Remove and Replace).
-
Release the clips (x5) that attach the
headliner at the front of the vehicle.
Note5x clips
-
Remove the LH map light bezel from the
headliner.
Note2x tabs, 1x alignment pin. Gently pry around edge of the bezel to release.
-
Disconnect the LH map light electrical
connector.
NoteLocking tab viewable from the rear edge of the front headliner.
-
Remove the LH map light from the
headliner.
Note2x tabs. Push up from interior to aid in releasing tabs.
Install
- Install the LH maplight to the headliner.
- Connect the electrical connector to the LH maplight.
-
Install the LH maplight bezel to
headliner.
NoteAlignment pin should face upward.
- Install the clips (x5) that attach the front portion of the headliner to the vehicle.
- Install the quad camera cover. See Upper Cover - Rear View Mirror (Remove and Replace).
- Install the rear view mirror. See Mirror - Rear View (Remove and Replace).
- Install the LH and RH sun visor. See Sun Visor - LH (Remove and Replace).
- Install the LH and RH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).