2022-06-17

Sensor - Air Quality (Remove and Replace)

Correction code 18107002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect the air quality sensor electrical connector.
  4. Lift the locking tab and rotate the air quality sensor counter-clockwise, and then remove the sensor from the vehicle.

Install

  1. Position the air quality sensor into the vehicle, and then rotate the sensor clockwise until the locking tab engages.
  2. Connect the air quality sensor electrical connector.
  3. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  4. Raise the LH front window and close the LH front door.