17/06/2022 13:26:41

Radar - Interior (Remove and Replace)

Correction code 17200012 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  2. Remove the LH IP end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  3. Remove the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  4. Remove the driver sun visor. See Sun Visor - LH (Remove and Replace).
  5. Repeat step 1 through step 4 for the RH side of the vehicle.
  6. Remove the lower quad camera cover. See Camera Cover - Lower (Remove and Replace).
  7. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  8. Remove the upper quad camera cover. See Upper Cover - Rear View Mirror (Remove and Replace).
  9. Release the clips (x5) that attach the front of the headliner to the vehicle.
  10. Release the locking tab, and then depress the black to disconnect the interior radar assembly.
  11. Remove the bolt that attaches the interior radar to body.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt is captive inside radar housing and cannot be removed from the radar assembly.
    Tip: Use of the following tool(s) is recommended:
    • T30 socket
  12. Release the clip that attaches the interior radar to the body, and then remove the radar from the vehicle.

Install

  1. Position the interior radar into the vehicle, and then secure the clip that attaches the radar to the body.
  2. Install the bolt that attaches the interior radar to body.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The bolt is captive inside radar housing.
    Tip: Use of the following tool(s) is recommended:
    • T30 socket
  3. Connect the interior radar assembly, and then engage the locking tab.
  4. Secure the clips (x5) that attach the front of the headliner to the vehicle.
  5. Install the upper quad camera cover. See Upper Cover - Rear View Mirror (Remove and Replace).
  6. Install the rear view mirror. See Mirror - Rear View (Remove and Replace).
  7. Install the front passenger visor. See Sun Visor - LH (Remove and Replace).
  8. Instal the RH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  9. Install the RH IP end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  10. Install the RH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  11. Repeat step 7 through step 10 for the RH side of the vehicle.
  12. Install the lower quad camera cover. See Camera Cover - Lower (Remove and Replace).