2022-06-17

Noise Filter - Ground - Antenna (Remove and Replace)

Correction code 21300012 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  2. Remove the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
  3. Remove the upper liftgate trim. See Trim - Upper - Liftgate (Remove and Replace).
  4. Remove the fir clip from the LH BIW sonic bracket.
  5. Disconnect the LH antenna RF filter electrical connector.
  6. Remove the bolt that attaches the antenna ground noise filter to the vehicle, release the retaining clip, and then remove the antenna from the vehicle.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T30 bit

Install

  1. Position the antenna ground noise filter into the vehicle, and then install the bolt that attaches the antenna to the vehicle.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T30 bit
  2. Connect the LH antenna RF filter electrical connector.
  3. Secure the fir clip to the LH BIW sonic bracket.
  4. Install the upper liftgate trim. See Trim - Upper - Liftgate (Remove and Replace).
  5. Install the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
  6. Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).