03/06/2024 06:29:22

Park Brake Caliper - Release

Correction code 33051007 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2024-06-03: Added procedure using Service Mode.
  • 2023-10-25: Updated with new Toolbox routines.
Informational PurposesAn informational icon, calling your attention
Note
This procedure is performed in conjunction with certain component replacement procedures. This is not a standalone procedure.
Informational PurposesAn informational icon, calling your attention
Note
If it not possible to release the brake caliper, then most likely the caliper shaft has seized, or the caliper motor is damaged. See Park Brake Caliper - Caliper Seized/Motor Failure - Release

Release Parking Brake Using Service Mode

  1. Chock a rear wheel if necessary.
  2. Enable Service Mode from the touchscreen. See Service Mode (Enable and Disable).
  3. Unlock the Gateway. See Gateway (Unlock)
  4. On the touchscreen, under Vehicle Info, touch Chassis, under Chassis, touch Brakes, and then in the diagram, touch EPB Service Mode.
  5. Read the text displayed, and under Parameters, from the Action target drop-down menu, select BOTH, from the Action type drop-down menu, select START, and touch Run.
    Informational PurposesAn informational icon, calling your attention
    Note
    To release the parking brake on one side of the vehicle, select LEFT or RIGHT.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The vehicle may roll freely.
  6. The vehicle is now in EPB Service Mode.
  7. To disable EPB Service Mode, shift the vehicle into Park.

Release Parking Brake Using Toolbox

  1. Chock a rear wheel if necessary.
  2. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  3. Using Toolbox 3:
    1. Select the Actions tab and search for "EPB Service Mode".
    2. Select the ODIN routine PROC_EPB_X_SERVICE-MODESearch for routine in ToolboxEPB Enter Service ModeChassis / Brakes - EPB Service ModeChassis / Brakes - EPB Service Modehv / Rear Drive Unit Replacement - Release / Re-Engage Emergency Parking BrakeChassis / Brakes - EPB Service Mode, and then click the link of the routine.
    3. Under "Action_Target" select BOTH, and under "Action_Type" select START.
    4. Click RUN, and allow the routine to complete.
      Informational PurposesAn informational icon, calling your attention
      Note
      Press and hold the brake pedal while performing this routine.
      Informational PurposesAn informational icon, calling your attention
      Note
      To release the parking brake on one side of the vehicle, select LEFT or RIGHT under "Action_Target".
      Warning IconA warning icon, calling your attention to a possibly risky situation
      CAUTION
      The vehicle may roll freely.
  4. Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3 (Connect and Disconnect).
  5. Return to the procedure that requested to release the park brake calipers.

Engage

  1. Press and hold the park button to release EPB service mode and apply the parking brakes.
  2. Remove the wheel chock if necessary.
  3. Return to the procedure that requested to engage the park brake calipers.