2023-08-29

Stabilizer Bar - Front (Remove and Replace)

Correction code 31012202 2.34 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Suspension - Front (Torque)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut that attaches the stabilizer bar end link to the stabilizer bar
70 Nm (51.6 lbs-ft)
  • 15 mm combination wrench
  • 5 mm hex
Replace PN - 1659754-00-A
Nuts (x4) that attach the front stabilizer bar to the front subframe assembly
50 Nm (36.9 lbs-ft)
  • 15 mm deep socket
Replace Access to these bolts require front subframe drop. PN - 1659754-00-A

Remove

  1. Remove the front subframe assembly. See Subframe Assembly - Front (Remove and Install).
  2. Remove and discard the nuts (x4) that attach the front stabilizer bar to the front subframe assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm deep socket
    Informational PurposesAn informational icon, calling your attention
    Note
    Discard the nuts after removal.

Install

  1. Install new nuts (x4) that attach the front stabilizer bar to the front subframe assembly.
    50 Nm (36.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 15 mm deep socket
  2. Install the front subframe assembly. See Subframe Assembly - Front (Remove and Install).
  3. Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.