15/03/2023 06:24:00

Seal - Body - Side - Front - Primary - LH (Remove and Replace)

Correction code 11700302 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH B-pillar applique. See Applique - B-Pillar - LH (Remove and Replace).
  2. Remove the clips (x2) that attach the LH primary front side body seal to the B-pillar.
  3. Release the LH primary front side body seal from the bright molding.
  4. Remove the clips (x3) that attach the LH primary front side body seal to the body.
  5. Remove the LH primary front side body seal from the vehicle.

Install

  1. Use IPA wipes to clean any residue from LH primary front side body seal area on the body.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow at least 1 min for dry time.
  2. Align the LH primary front side body seal onto the vehicle, secure the clips (x5) to the body, and then remove the adhesive backing and adhere the seal to the body along the installation path.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the seal is seated properly along the bright molding and interior trim.
  3. Install the LH B-pillar applique. See Applique - B-Pillar - LH (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to perform service redeploy after installation.
  4. Recalibrate the LH window. See Window Regulator (Recalibrate).
  5. Confirm that the window operates correctly and without any abnormal noise.
  6. Connect a laptop with Toolbox 3 to the vehicle.
  7. In Toolbox, click the Dashboards tab, and then search for "Service Tools".
  8. Click the Clear Calibration Pillars button.
    Informational PurposesAn informational icon, calling your attention
    Note
    Confirm that there is a successfully cleared calibration message.
  9. Exit the vehicle, and then click DAS Image Capture.
    Informational PurposesAn informational icon, calling your attention
    Note
    The vehicle needs to be unoccupied in order for the ride height to maintain specifications.
  10. Review the images and make sure all the cameras are able to capture the image correctly.
  11. Disconnect Toolbox 3 and remove the laptop from the vehicle.
  12. Inform the customer that the vehicle will need to be driven to complete the calibration procedure. During this time, DAS functions will be completely unavailable.