2023-12-04

Harness - Sub-Assembly - Instrument Panel (Remove and Replace)

Correction code 17100612 1.44 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-10-12: Reorganized the procedure.

Remove

  1. Remove the instrument panel sub-assembly. See Sub Assembly - Instrument Panel (Remove and Install).
  2. Disconnect the air wave ventilation connectors (x4).
    Informational PurposesAn informational icon, calling your attention
    Note
    Position the sub-assembly upside down on a protective surface to access the connectors.
  3. Remove the LH and RH side window defrost ducts. See Duct - Side Window Defrost - LH (Remove and Replace).
  4. Remove the clips (x13) that attach the instrument panel sub-assembly harness to the vehicle.

Install

  1. Install the clips (x13) that attach the instrument panel sub-assembly harness to the vehicle.
  2. Install the LH and RH side window defrost ducts. See Duct - Side Window Defrost - LH (Remove and Replace).
  3. Connect the air wave ventilation connectors (x4).
    Informational PurposesAn informational icon, calling your attention
    Note
    Position the sub-assembly upside down on a protective surface to access the connectors.
  4. Install the instrument panel sub-assembly. See Sub Assembly - Instrument Panel (Remove and Install).