Carrier - RH - Side Shield - Inboard - Front Seat (Remove and Replace)
Correction code 13070042 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Remove the driver seat from the vehicle. See Seat Assembly - 1st Row - LH (Remove and Replace).
- Remove the driver seat inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).
-
Release the clips (x2) and tabs (x2)
that attach the front seat side shield RH carrier to the front seat.
NoteRelease leading edge of trim, and then slide the trim away from the seat frame.
Install
-
Position the front seat side shield RH
carrier onto the LH front seat, and then slide the carrier forward onto the frame to
align the clips (x2) and tabs (x3).
- Install the driver seat inboard side shield. See Side Shield - Inboard - Driver Seat (Remove and Replace).
- Install the driver seat. See Seat Assembly - 1st Row - LH (Remove and Replace).