17/06/2022 13:21:28

Trim - Side - Trunk - RH (Remove and Replace)

Correction code 15245102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Fold down the RH (40 split) 2nd row seat.
  2. Remove the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  3. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  4. Remove the rear wall rear trunk trim. See Trim - Rear Trunk - Rear Wall (Remove and Replace).
  5. Remove the RH trunk load floor bracket. See Bracket - Trunk Load Floor - RH (Remove and Replace).
  6. Remove the trunk floor front trim. See Trim - Front - Floor - Trunk (Remove and Replace).
  7. Remove the RH 2nd row seat outer bolster. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  8. Release the clips (x4) and tab that attach the RH lower C-pillar trim to the RH middle C-pillar trim.
  9. Remove the RH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  10. Release the clips (x7) that attach the RH upper C-pillar trim to the vehicle, and then move the upper C-pillar trim aside.
    Informational PurposesAn informational icon, calling your attention
    Note
    The RH upper C-pillar trim is still tethered to the seatbelt.
  11. Release the clips (x3) that attach the RH trunk side trim, and then disconnect the electrical connector.
  12. Remove the RH trunk side trim from the vehicle.

Install

  1. Position the RH trunk side trim on the vehicle.
  2. Connect the electrical connector on the RH trunk side trim, and then install the clips (x3) that attach the trim to the vehicle.
  3. Position the RH upper C-pillar trim on the vehicle, and then install the clips (x7) that attach the trim to the vehicle.
  4. Install the RH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  5. Install the clips (x4) and tab that attach the RH lower C-pillar trim to the RH middle C-pillar trim.
  6. Install the RH 2nd row seat outer bolster. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  7. Install the rear wall rear trunk trim. See Trim - Rear Trunk - Rear Wall (Remove and Replace).
  8. Install the trunk floor front trim. See Trim - Front - Floor - Trunk (Remove and Replace).
  9. Install the RH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  10. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  11. Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  12. Restore the RH 2nd row seat to the upright position.