2022-06-17

Actuator - Latch - Hood (Single Actuator System) (Remove and Replace)

Correction code 11350402 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH front door.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  4. Remove the front underhood apron. See Underhood Apron - Front (Remove and Replace).
  5. Remove underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  6. Release the clips that attach the FEM harness to the front end carrier assembly.
  7. Release the locking tab, and then disconnect the hood latch actuator and cable assembly electrical connector.
  8. Compress the tabs (x2) to release the hood latch actuator and cable from the hood latch assembly.
  9. Release the clip that attaches the hood latch actuator and cable assembly to the vehicle.
  10. Remove the bolts (x2) that attach the hood latch actuator and cable assembly to the vehicle, and then remove the assembly from the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench

Install

  1. Position the hood latch actuator and cable assembly into the vehicle, and then install the bolts (x2) that attach the assembly to the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
  2. Install the clip that attaches the hood latch actuator and cable assembly to the vehicle.
  3. Install the hood latch actuator and cable into the double pull single actuator hood latch assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the tabs are fully engaged onto the hood latch assembly.
  4. Connect the hood latch actuator and cable assembly electrical connector, and then engage the locking tab.
  5. Install the clips that attach the FEM harness to the front end carrier assembly.
  6. Install underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  7. Install the front underhood apron. See Underhood Apron - Front (Remove and Replace).
  8. Install the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace).
  9. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).