Hose - Washer - Shock Tower - LH (Remove and Replace)
Correction code
17501612
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Remove the LH underhood apron. See Underhood Apron - LH (Remove and Replace).
-
Disconnect the shock tower hose from
the washer tank hose.
-
Release the clips (x3) that attach the
washer hose to the LH shock tower cover, and then remove shock tower washer hose from
the vehicle.
Install
-
Install the shock tower washer hose to
the clips (x3) that attach the washer hose to the LH shock tower cover.
-
Connect the shock tower hose to the
washer tank hose
- Install the LH underhood apron. See Underhood Apron - LH (Remove and Replace).
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).