17/06/2022 13:22:34

Insulator - Motor Bay - Front (Remove and Replace)

Correction code 15308602 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Move the driver and front passenger seats fully forward.
  2. Remove the LH and RH 2nd row seat outer bolsters. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  3. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  4. Remove the LH and RH 2nd row cushion support blocks. See Support Block - 2nd Row Cushion - LH (Remove and Replace).
  5. Release the clips (x5) that attach the electrical harness to the front motor bay insulator.
  6. Remove the front motor bay insulator trim from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Material type for the trim may differ depending on the vehicle.

Install

  1. Install the front motor bay insulator onto the vehicle.
  2. Secure the clips (x5) that attach the electrical harness to the front motor bay insulator.
  3. Install the LH and RH 2nd row cushion support blocks. See Support Block - 2nd Row Cushion - LH (Remove and Replace).
  4. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  5. Install the LH and RH 2nd row seat outer bolsters. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  6. Move the driver and front passenger seats back to their original position.