18/05/2023 14:50:47

Cover - Footwell - Driver (Remove and Replace)

Correction code 14055302 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH front door.
  2. Move the driver seat fully rearwards.
  3. Pull down to release the magnets that attach the driver footwell cover to the vehicle, but do not remove the cover as there is a electrical connector still connected.
    Informational PurposesAn informational icon, calling your attention
    Note
    The cover is secured using magnets.
  4. Disconnect the electrical connector, and then remove the footwell cover from the vehicle.

Install

  1. Position the driver footwell cover in the vehicle, and then connect the electrical connector.
  2. Secure the footwell cover into place.
    Informational PurposesAn informational icon, calling your attention
    Note
    The cover is secured using magnets.
  3. Move the driver seat to its original position.
  4. Close the LH front door.