Sensor - Ride Height - Front - LH (Remove and Replace)
Correction code
31102802
0.42
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Raise and support the vehicle.
- Remove the LH front wheel. See Wheel Assembly (Remove and Install).
- Release the clip that attaches the LH front wheel liner to the vehicle.
- Disconnect the electrical harness from the LH front ride height sensor.
- Remove the nut that attaches the LH front ride height sensor to the control arm.
-
Remove the bolt that attaches the LH
front ride height sensor to the vehicle, and remove the sensor from the vehicle.
Note1x bolt, 10mm, 5 Nm, 1x datum, 1x tab
Install
-
Position the tab and install the bolt
that attaches the LH front ride height sensor to the vehicle.
Note1x bolt, 10mm, 5 Nm, 1x datum, 1x tab
-
Using a new nut, install the arm that
attaches the LH front ride height sensor to the control arm.
Note1x nut, 10mm, 8 NmCAUTIONDo not bind or invert the orientation of the sensor arm.
- Connect the electrical harness to the LH ride height sensor.
-
Position the clip that attaches the LH
front wheel liner to the vehicle.
Note1x clip
- Install the LH front wheel. See Wheel Assembly (Remove and Install).
- Remove the vehicle from the lift.
- Perform a ride height adjustment. See Ride Height (Adjust).