Heater - Radar (Rework) (Vehicles Built After July 1, 2021)
     Correction code
    17201806
                                                  0.42
                                                  
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
    Correction code
    17201806
                                                  0.42
                                                  
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate Times to learn
          more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
        
        
          NOTE: See Personal Protection to make sure proper PPE is worn when
          performing the below
          procedure.
      
  
- 2025-04-02: Updated PN of the harness-side connector plug.
- 2024-12-18: Updated title and procedure details.
Rework
- Remove the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
- 
          Disconnect the radar heater electrical
            connector.
          
- 
          Cut the radar heater harness near the
            radar heater.
          
- 
          Install a dummy plug (1015346-00-B)
            onto the fascia harness that goes to the radar heater.
          
- 
          Insert plugs (1015293-00-A x2) onto
            the back of the connector dummy plug.
          
- Install the front fascia assembly. See Fascia Assembly - Front (Remove and Install).