2023-01-09

Hose - Inverter to Heat Exchanger - Front Drive Unit (Remove and Replace)

Correction code 18300132 3.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the HV battery. See HV Battery (AWD) (Remove and Install).
  2. Remove the bolts (x3) that attach the LH toeboard brace to the vehicle, and then remove the brace from the vehicle.
    30 Nm (22.1 lbs-ft)
  3. Position a coolant drain container under the front of the vehicle.
  4. Release the hose clip, release the front drive unit inverter to heat exchanger hose from the heat exchanger, and then plug the male and female fittings.
  5. Release the clips (x4) that attach the front drive unit inverter to heat exchanger hose to the front drive unit.
  6. Release the hose clip, release the front drive unit inverter to heat exchanger hose from the fluid coupling, and then remove the hose from the vehicle.

Install

  1. Remove the plugs, install the front drive unit inverter to heat exchanger hose to the fluid coupling, and then secure the hose clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a pull-push-pull test to make sure the hose is secure.
  2. Secure the clips (x4) that attach the front drive unit inverter to heat exchanger hose to the front drive unit.
  3. Remove the plugs, install the front drive unit inverter to heat exchanger hose to the heat exchanger, and then secure the hose clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a pull-push-pull test to make sure the hose is secure.
  4. Secure the front drive unit logic connector clip.
  5. Remove the coolant drain container from underneath the vehicle.
  6. Position the LH toeboard brace into the vehicle, and then install the bolts (x3) that attach the brace to the vehicle.
    30 Nm (22.1 lbs-ft)
  7. Install the HV battery. See HV Battery (AWD) (Remove and Install).