12/09/2023 15:15:50

SD Card - Car Computer (Remove and Replace)

Correction code 21152502 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-09-12: Cleaned up procedure.
  • 1607771-00-A, MICRO SD CARD, INSTALLATION TOOL, HW3
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the RH front door and lower the RH front window.
  2. Move the front passenger seat fully rearwards.
  3. Open the hood.
  4. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  5. Disconnect LV power. See LV Power (Disconnect and Connect).
  6. Remove the front passenger floor mat.
  7. Remove the passenger footwell cover. See Cover - Footwell - Passenger (Remove and Replace).
  8. Remove the RH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  9. Remove the RH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  10. Fold the RH front cabin carpet aside for access.
  11. Remove the RH center console side panel. See Side Panel - Center Console - LH (Remove and Replace).
  12. Release harness from RH footrest panel. See .
    Informational PurposesAn informational icon, calling your attention
    Note
    1x clip
  13. Remove the front passenger footrest panel. See Panel - Footrest - Front Passenger (LHD) (Remove and Replace).
  14. Release the SD card from the slot in the car computer, and then remove the SD card from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    x1 retaining tab.
    Informational PurposesAn informational icon, calling your attention
    Note
    Eject the SD card by sliding the locking tab away from the SD card. The SD card may eject quickly and fall. Once ejected and the SD card is still in car computer slot, it can be removed with tweezers.
    Informational PurposesAn informational icon, calling your attention
    Note
    Destroy the removed SD card.

Install

  1. Secure the SD card to the install guide.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the install guide slide is in the down position. Slide the SD card into the top of the tool from left to right until fully seated.
    Informational PurposesAn informational icon, calling your attention
    Note
    SD card contacts should be facing rearward during installation.
  2. Install the SD card.
    Informational PurposesAn informational icon, calling your attention
    Note
    Guide the SD card into the slot. Insert the guide to the stop. Slide the guide locking tab upward until an audible click and lock of the SD card. Remove the guide and confirm the SD card is fully seated.
  3. Install the front passenger footrest panel. See Panel - Footrest - Front Passenger (LHD) (Remove and Replace).
  4. Fold the RH main carpet back into place.
  5. Install the RH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  6. Install the RH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
  7. Install the RH center console side panel. See Side Panel - Center Console - LH (Remove and Replace).
  8. Install the passenger footwell cover. See Cover - Footwell - Passenger (Remove and Replace).
  9. Install the front passenger floor mat.
  10. Reconnect LV power. See LV Power (Disconnect and Connect).
  11. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  12. Close the hood.
  13. Restore the front passenger seat back to its original position.
  14. Raise the RH front window and close the RH front door.