20/12/2022 10:07:46

Striker - Seat Back - 2nd Row Seat - LH (Remove and Replace)

Correction code 13056302 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the LH rear door.
  3. Fold the LH rear seat down.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the rear seat cushion is not present, protect the seat as necessary.
  4. Remove the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  5. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  6. Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  7. Remove the rear wall rear trunk trim. See Trim - Rear Trunk - Rear Wall (Remove and Replace).
  8. Remove the LH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  9. Remove the trunk floor front trim. See Trim - Front - Floor - Trunk (Remove and Replace).
  10. Remove the LH 2nd row seat outer bolster. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  11. Remove the LH trunk side trim. See Trim - Side - Trunk - LH (Remove and Replace).
  12. Remove the bolts (x2) that attach the seat back striker to the body, and then remove the striker from the vehicle.
    26 Nm (19.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 11 mm deep socket

Install

  1. Install the bolts (x2) that attach the seat back striker to the body.
    26 Nm (19.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 11 mm deep socket
  2. Install the LH trunk side trim. See Trim - Side - Trunk - LH (Remove and Replace).
  3. Install the LH 2nd row seat outer bolster. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  4. Install the trunk floor front trim. See Trim - Front - Floor - Trunk (Remove and Replace).
  5. Install the LH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  6. Install the rear wall rear trunk trim. See Trim - Rear Trunk - Rear Wall (Remove and Replace).
  7. Install the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  8. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  9. Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  10. Fold the LH rear seat into vertical position.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove seat cushion protection, if added.
  11. Close the LH rear door.
  12. Raise the LH front window and close the LH front door.