15/06/2023 14:31:49

Brake Hose - Flexible - Rear - LH (Remove and Replace)

Correction code 33030502 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift
  2. Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
  3. Release the clip that attaches the air lines to the LH rear brake hose bracket.
  4. Remove the bolt that attaches the LH rear brake hose from the LH rear lower control arm.
  5. Position an oil drain beneath the LH rear corner of the vehicle.
  6. Remove the banjo bolt that attaches the brake hose to the LH rear brake caliper. Catch any fluid lost in the oil drain.
  7. Loosen the nut that attaches the brake line to the LH rear flexible brake hose, and then disconnect the brake line from the brake hose.
    Informational PurposesAn informational icon, calling your attention
    Note
    Catch any fluid lost in a waste container.
    Tip: Use of the following tool(s) is recommended:
    • Combination wrench 12pt 12mm
  8. Remove the clip that attaches the LH rear flexible brake hose to the bracket.
  9. Remove the LH rear brake hose from the vehicle.

Install

  1. Position the LH rear flexible brake hose on the vehicle.
  2. Install the clip that attaches the LH rear flexible brake hose to the bracket.
  3. Connect the brake line to the LH rear flexible brake hose, and then install the nut that attaches the brake line to the brake hose.
    16 Nm (11.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Catch any fluid lost in a waste container.
    Tip: Use of the following tool(s) is recommended:
    • 3/8in Dr. Open Crowfoot Socket x 12mm
    • Adapter 1/4in Dr. to 3/8in Dr.
    • Combination wrench 12pt 12mm
    • Ratchet/torque wrench
  4. Install the brake hose to the LH rear brake caliper.
    42 Nm (31.0 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 11 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
  5. Remove the oil drain from the LH rear corner of the vehicle.
  6. Install the bolt that attaches the LH rear brake hose to the LH rear lower control arm.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Ratchet/torque wrench
  7. Install the clip that attaches the air lines to the LH rear brake hose bracket.
  8. Perform a brake fluid flush on the LH rear wheel. See Brake Fluid Bleed/Flush (Remove and Replace).
  9. Perform vehicle road test using a series of ABS-active stops and make sure proper brake pedal feel and performance is achieved.