2023-05-18

Trim - Liftgate Trough - LH (Remove and Replace)

Correction code 12270402 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the liftgate.
  2. Remove the LH side liftgate stop by turning it counterclockwise.
  3. Remove the LH liftgate trough trim by releasing the upper portion of the liftgate seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Gently pull the top portion of the liftgate trough trim away from the vehicle.

Install

  1. Use an Isopropyl Alcohol (IPA) wipe to clean any adhesive residue or dirt. Allow the area to dry for 1 minute before continuing.
    Informational PurposesAn informational icon, calling your attention
    Note
    Cleaning the surface will allow the new adhesive to stick to the body properly.
  2. Apply double sided tape adhesive onto the back side of the LH liftgate trough trim, if the new trim does not come with tape.
  3. Install the LH liftgate trough trim:
    1. Slide the edge of the liftgate trough trim under the tail light.
    2. Slowly push the trim downward toward the quarter panel.
      Informational PurposesAn informational icon, calling your attention
      Note
      Verify the bottom tabs are positioned behind the bumper.
    3. Fully seat the seal over the trim.
  4. Install the LH side liftgate stop by turning it clockwise.
    Informational PurposesAn informational icon, calling your attention
    Note
    Hand tight the side liftgate stop only.
  5. Close the liftgate.