2023-08-24

Painted Bracket - Molding - License Plate - Front (Remove and Replace)

Correction code 12070402 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  1. Remove front license plate with decorative frame from original fascia
    Informational PurposesAn informational icon, calling your attention
    Note
    4x Screws,T20, 3 Nm
  2. Remove the front license plate molding painted bracket from the front fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    3x Bolts, E10 5 Lobe, 1 Nm
  3. Install the new front license plate molding painted bracket on the front fascia.
    Informational PurposesAn informational icon, calling your attention
    Note
    3x Bolts, E10 5 Lobe, 1 Nm
  4. Install license plate with decorative frame
    Informational PurposesAn informational icon, calling your attention
    Note
    4x Screws,T20, 3 Nm