Switch - Brake Light (Remove and Replace)
Correction code 33252002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
- 2023-12-15: Removed brake stiffness routine.
Remove
- Move the LH front seat rearwards.
- Disconnect LV power. See LV Power (Disconnect and Connect).
- Remove the driver footwell cover. See Cover - Footwell - Driver (Remove and Replace).
- Remove the driver knee airbag. See Knee Airbag - Driver (Remove and Replace).
-
Release the tab that attaches the driver floor jumper air duct to the HVAC assembly, and then remove the duct from the vehicle.
-
Disconnect the LH body harness connector.
Tip: Use of the following tool(s) is recommended:
- Flashlight LED
- Pick Miniature Soft Grip, 90 degree tip, 6 in
-
Release the brake light switch from the pedal assembly, and then remove the switch from the vehicle.
NoteRotate the switch 45 degrees clockwise to release.Tip: Use of the following tool(s) is recommended:
- Flashlight LED
- Pick Miniature Soft Grip, 90 degree tip, 6 in
Install
-
Position the brake light switch on the vehicle, and then install the switch on the pedal assembly.
NoteRotate the switch 45 degrees counter-clockwise to install.Tip: Use of the following tool(s) is recommended:
- Flashlight LED
-
Connect the LH body harness connector.
Tip: Use of the following tool(s) is recommended:
- Flashlight LED
-
Position the driver floor jumper air duct on the vehicle, and then install the tab that attaches the duct to the HVAC assembly.
- Install the driver knee airbag. See Knee Airbag - Driver (Remove and Replace).
- Install the driver footwell cover. See Cover - Footwell - Driver (Remove and Replace).
- Connect LV power. See LV Power (Disconnect and Connect).
- Move the LH front seat to its original position.