04/08/2023 15:34:05

Trim - Middle - Instrument Panel - RH (Remove and Replace)

Correction code 14050062 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
  • 2023-08-04: Added steps.

Remove

  1. Open the RH front door and lower the RH front window.
  2. Move the front passenger seat fully rearward.
  3. Open the glove box.
  4. Open the hood.
  5. Disconnect LV power. See LV Power (Disconnect and Connect).
  6. Remove the RH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  7. Remove the RH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  8. Remove the center console phone dock as an assembly, but do not remove the inductive charger from the phone dock. See Phone Dock - Center Console (Remove and Replace).
  9. Remove the instrument panel service panel as an assembly, but do not remove the cabin temperature sensor fan from the service panel. See Service Panel - Instrument Panel (Remove and Replace).
  10. Remove the touchscreen as an assembly, but do not remove the display mechanism from the touchscreen. See Touchscreen (HW3) (Remove and Replace).
  11. Release the tabs (x4) that attach the instrument panel closeout panel to the instrument panel, and then remove the closeout panel from the vehicle.
  12. Release the tabs (x14) that attach the RH instrument panel middle trim to the instrument panel, and then remove the trim from the vehicle.

Install

  1. Fasten the tabs (x14) that attach the RH instrument panel middle trim to the instrument panel.
  2. Fasten the tabs (x4) that attach the instrument panel closeout panel to the instrument panel.
  3. Install the touchscreen. See Touchscreen (HW3) (Remove and Replace).
  4. Install the instrument panel service panel. See Service Panel - Instrument Panel (Remove and Replace).
  5. Install the center console phone dock. See Phone Dock - Center Console (Remove and Replace).
  6. Reconnect LV power. See LV Power (Disconnect and Connect).
  7. Close the hood.
  8. Install the RH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  9. Install the RH middle A-pillar trim. See Trim - A-Pillar - Middle - LH (Remove and Replace).
  10. Restore the front passenger seat back to its original position.
  11. Raise the RH front window and close the RH front door.