2024-05-30

Trim - Sill - Trunk (Remove and Replace)

Correction code 15244802 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the liftgate.
  2. Remove the rear trunk parcel shelf, if installed.
  3. Remove the rear trunk load floor, if installed.
  4. Use a plastic pry tool to release the clips (x6) that attach the trunk sill trim to the trunk sill, and then remove the trim from the vehicle.

Install

  1. Position the trunk sill trim to the trunk sill, align the guides (x4) to the trunk sill, and then fasten the clips (x6) that attach the trim to the sill.
  2. Install the rear trunk load floor, if removed.
  3. Install the rear trunk parcel shelf, if removed.
  4. Close the liftgate.