Cap - Reservoir - Windshield Washer (Remove and Replace)
Correction code
17501202
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open the hood and remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Remove the LH underhood apron. See Underhood Apron - LH (Remove and Replace).
-
Remove the washer cap from the washer
bottle with a plastic pry tool.
Install
-
Install the cap to the washer
bottle.
TIpPress the washer cap down on the bottle until it fully seats.
- Install the LH underhood apron. See Underhood Apron - LH (Remove and Replace).
- Install the rear underhood apron and close the hood. See Underhood Apron - Rear (Remove and Replace).