17/06/2022 13:29:12

Hose - Washer - Reservoir (Remove and Replace)

Correction code 17501512 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the LH underhood apron. See Underhood Apron - LH (Remove and Replace).
  3. Release the shock tower hose from the washer tank hose.
  4. Remove the retainer clip from the washer bottle.
  5. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  6. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  7. Release the clips (x7) that attach the front portion of the LH front wheel house liner to the vehicle.
  8. Release the hooks (x3) that attach the washer hose to the washer reservoir.
  9. Release the tabs (x2) that attach the washer hose to the reservoir.
    Informational PurposesAn informational icon, calling your attention
    Note
    2x tabs
  10. Disconnect washer hose from the washer pump.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful when separating hose from washer pump as to not damage the washer pump.
  11. Remove the washer hose from the vehicle.

Install

  1. Install the washer hose to the vehicle.
  2. Connect the washer hose to the washer pump.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage the washer pump when connecting the washer hose.
  3. Install the washer hose to the tabs (x2) on the reservoir.
  4. Install the washer hose to the hooks (x3) on the reservoir.
  5. Install the clips (x7) that attach the front portion of the LH front wheel house liner.
  6. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  7. Remove the vehicle from the lift.
  8. Install the retainer clip to the washer bottle.
  9. Attach the shock tower hose to the washer tank hose.
  10. Install the LH underhood apron. See Underhood Apron - LH (Remove and Replace).
  11. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).