Sensor - Pressure - Door - Front - LH (Remove and Replace)
Correction code
20200102
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Remove the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
- Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace)
-
Release the connector lock, and then
disconnect the LH front door pressure sensor electrical connector.
CAUTIONDo not push down on red tab. Pull the red tab to disengage lock, and then pull the connector to release it.
- Rotate the LH front door pressure sensor counterclockwise to remove it from the closeout panel.
Install
-
Position a new LH front door pressure
sensor onto the closeout panel, and then rotate the sensor clockwise to secure it to the
panel.
NoteVerify the sensor is locked in place.
- Connect the LH front door pressure sensor electrical connector, and then engage the locking tab.
- Install the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace)