2022-06-17

Seal - Door - Rear - Margin - B Pillar - LH (Remove and Replace)

Correction code 11700032 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Release the clip that attaches the top corner of LH B-pillar margin rear door seal to the LH rear door, and then release the top edge of the margin seal from the door assembly.
  2. Release the clips (x2) and adhesive that attach LH B-pillar margin rear door seal to the vehicle.

Install

  1. Use IPA wipes to remove any dirt or residual adhesive from the mating surface on the LH rear door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow 1 minute of dry time.
  2. Position the LH B-pillar margin rear door seal onto the LH rear door, fasten the clips (x2), and then remove the adhesive backing and adhere the seal onto the door assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace double sided tape as necessary.
  3. Place the top edge of the LH B-pillar margin rear door seal into position, and then fasten the clip that attaches the top corner of margin seal to the door assembly.