02/08/2023 13:19:26

Filter - HEPA (Remove and Replace)

Correction code 18105502 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-07-11: Reorganized the procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the clip that attaches the coolant hose to the LV battery.
  3. Remove the bolts (x3) that attach the LV battery to the vehicle, then move the LV battery aside.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not disconnect the LV battery harness.
    Informational PurposesAn informational icon, calling your attention
    Note
    Move the coolant hose above the LV battery.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • 4 in extension
  4. Disconnect the air quality sensor harness electrical connector.
  5. Remove the HEPA filter cover.
  6. Release the clips (x2) that attaches the HEPA filter to the vehicle.

Install

  1. Fasten the clips (x2) that attaches the HEPA filter to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the3 datums into the bottom of the HEPA filter.
  2. Install the HEPA filter cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    Maneuver the HEPA filter cover down and install it under the V-brace crossmember.
  3. Connect the air quality sensor harness electrical connector.
  4. Install the bolts (x3) that attach the LV battery to the vehicle.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Move the coolant hose under the LV battery.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Flex head ratchet/flex head torque wrench
    • Ratchet/torque wrench
    • 4 in extension
  5. Install the clip that attaches the coolant hose to the LV battery.
  6. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).