07/09/2022 11:14:54

Bracket - Grab Handle - Door - Rear - LH (Remove and Replace)

Correction Code: 15132012 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
  3. Remove the bolts (x2) that attach the LH rear door grab handle bracket to the door assembly, and then remove the bracket from the assembly.
    3.5 Nm (2.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 8 mm socket

Install

  1. Position the LH rear door grab handle bracket onto the door assembly, and then install the bolts (x2) that attach the bracket to the assembly.
    3.5 Nm (2.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 8 mm socket
  2. Install the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace).
  3. Raise the LH rear window and the LH rear door.