17/06/2022 13:22:06

Insulator - Motor Bay - Rear (Remove and Replace)

Correction code 15308502 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Move the driver and front passenger seats fully forward.
  2. Remove the LH and RH 2nd row seat outer boltsers. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  3. Remove the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  4. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  5. Remove the rear trunk trim. See Trim - Rear Trunk - Rear Wall (Remove and Replace).
  6. Remove the side trunk load floor. See Trunk Load Floor - Side (Remove and Replace).
  7. Remove the LH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  8. Remove the RH trunk load floor bracket. See Bracket - Trunk Load Floor - RH (Remove and Replace).
  9. Remove the trunk floor front trim. See Trim - Front - Floor - Trunk (Remove and Replace).
  10. Remove the rear trunk carpet. See Carpet - Rear Trunk (5 Seat) (Remove and Replace).
  11. Fold the edges out from under the LH and RH trunk side trims, and then remove the rear motor bay insulator from the vehicle.

Install

  1. Put the rear motor bay insulator inside the vehicle.
  2. Install the rear trunk carpet. See Carpet - Rear Trunk (5 Seat) (Remove and Replace).
  3. Install the trunk floor front trim. See Trim - Front - Floor - Trunk (Remove and Replace).
  4. Install the RH trunk load floor bracket. See Bracket - Trunk Load Floor - RH (Remove and Replace).
  5. Install the LH trunk load floor bracket. See Bracket - Trunk Load Floor - LH (Remove and Replace).
  6. Install the side trunk load floor. See Trunk Load Floor - Side (Remove and Replace).
  7. Install the rear trunk trim. See Trim - Rear Trunk - Rear Wall (Remove and Replace).
  8. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  9. Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  10. Install the LH and RH 2nd row seat outer boltsers. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace).
  11. Move the driver and front passenger seats back to their original position.