17/06/2022 13:31:23

Duct - Instrument Panel - Driver (Remove and Replace)

Correction code 18108002 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the IP sub-assembly. See Sub Assembly - Instrument Panel (Remove and Install).
  2. Release the rivets (x2) that attach the driver IP air vent duct to the HVAC assembly, disconnect the electrical connector, and then slide the duct out and up to remove it from the assembly.

Install

  1. Position the driver instrument panel duct into the HVAC assembly, connect the electrical connector, and then fasten the rivets (x2) that attach the duct to the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide the duct inboard and into the HVAC unit assembly.
  2. Install the instrument panel sub-assembly and all other parts that were removed for access. See Sub Assembly - Instrument Panel (Remove and Install).