2026-08-09

Actuator - Duct - Footwell - LH (Remove and Replace)

Correction code 18108612 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Move the driver seat fully rearwards.
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Disconnect LV power. See LV Power (Disconnect and Connect).
  4. Remove the driver footwell cover. See Cover - Footwell - Driver (Remove and Replace).
  5. Remove and discard the patch bolts (x2) that attach the driver knee airbag assembly to the instrument panel.
    Tip
    Use of the following tool(s) is recommended:
    • 2 in extension
    • Ratchet/torque wrench
    • External Torx E10
    • ¼ in to 3/8 in adapter
  6. Release the tabs (x6) that attach the driver knee airbag assembly to the instrument panel, and then partially lower the airbag.
    CAUTION
    The driver knee airbag is still connected to the vehicle. Be careful not to damage the electrical connectors when lowering the airbag from the instrument panel.
  7. Remove the screws (x2) that attach the LH footwell duct actuator to the vehicle.
    2.3 Nm (1.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • T20 bit
  8. Disconnect the LH footwell duct actuator electical connector, and then remove the actuator from the vehicle.

Install

  1. Position the LH footwell duct actuator into the vehicle, and then connect the electrical connector.
  2. Install the screws (x2) that attach the LH footwell duct actuator to the vehicle.
    2.3 Nm (1.7 lbs-ft)
    Note
    Make sure the keyed socket angle matches the actuator upon installation.
    Tip
    Use of the following tool(s) is recommended:
    • T20 bit
  3. While supporting the driver knee airbag assembly, connect the electrical connectors (x3).
    CAUTION
    Carefully connect the airbag electrical connector to prevent damage to the electrical connectors.
  4. Hook the tabs (x6) before putting the driver knee airbag onto the instrument panel, and then seat the airbag to the instrument panel.
  5. Install the new patch bolts (x2) that attach the driver knee airbag to the instrument panel.
    8 Nm (5.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 2 in extension
    • Ratchet/torque wrench
    • External Torx E10
    • ¼ in to 3/8 in adapter
  6. Install the driver footwell cover. See Cover - Footwell - Driver (Remove and Replace).
  7. Connect LV power. See LV Power (Disconnect and Connect).
  8. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  9. Return the driver seat to its original position.