2022-06-17

Seatbelt - 2nd Row - Center (Remove and Replace)

Correction code 20056302 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH 2nd row seat should trim. See Trim - Shoulder - Seat - 2nd Row - LH (Remove and Replace).
  2. Remove and discard the bolt that attaches the center 2nd row seatbelt to the seat assembly, and then lift the seatbelt upward and out of the slotted opening in the backrest assembly to remove it from the assembly.
    45 Nm (33.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T50 socket

Install

  1. Insert the center 2nd row seatbelt and slide the seatbelt down into the slotted opening in backrest assembly, and then install a new bolt that attaches the seatbelt to the seat assembly.
    45 Nm (33.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T50 socket
  2. Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace).
  3. Install the LH 2nd row seat should trim. See Trim - Shoulder - Seat - 2nd Row - LH (Remove and Replace).