2026-08-09

Damper Wedge - Liftgate - LH (Remove and Replace)

Correction code 11330072 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the liftgate.
  2. Remove the liftgate damper wedge cover.
  3. Remove the screw that attaches the liftgate damper wedge to the liftgate, and then remove it from the vehicle.
    12 Nm (8.8 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Flex head ratchet/flex head torque wrench

Install

  1. Use IPA wipes to clean the double sided tape residue from the liftgate.
    Note
    Allow 1 minute of dry time.
  2. Remove the backing from the double sided tape on LH liftgate damper wedge, position the damper wedge onto the liftgate, and then install the screw that attaches the damper wedge to the liftgate.
    12 Nm (8.8 lbs-ft)
    Note
    Align the damper wedge to the screw insert.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Flex head ratchet/flex head torque wrench
  3. Install the liftgate damper wedge cover.
    Note
    The liftgate damper wedge cover is separate from liftgate damper wedge. If the cover tabs are broken during removal, order PN 1012174-00-A.
  4. Close the liftgate.