2022-06-17

Striker - Door - Front - LH (Remove and Replace)

Correction code 11353002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Striker - Door - Front - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the LH front door striker to the vehicle
22 Nm (16.2 lbs-ft)
  • Torx T40 socket
  • Ratchet/torque wrench
 Reuse

Remove

  1. Open the LH front door.
  2. Use masking tape to mark the position of the door striker to the vehicle.
  3. Remove the two bolts that attach the door striker to the vehicle, and then remove the door striker from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 socket
    • Ratchet/torque wrench

Install

  1. Using the masking tape as a guide, install the door striker to the vehicle, but do not fully torque the bolts.
  2. Close the LH front door and use the gap and flush tool to verify the door alignment is within specification.
  3. Open the LH front door and adjust the striker position as necessary.
  4. Torque the bolts that attach the door striker to the vehicle.
    22 Nm (16.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T40 socket
    • Ratchet/torque wrench
  5. Remove the masking tape from vehicle.
  6. Close the LH front door.