2026-03-05

Camera - Fascia - Front (2025+) (Remove and Replace)

Correction code 17220200502 17220200501 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-03-04: Released new procedure.

Remove

  1. Open the LH front door.
  2. Lower the LH front window.
  3. Place the vehicle in service mode. See Service Mode (Enable and Disable).
  4. Remove the screws (x2), then remove front fascia camera cover.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  5. Disconnect the locking tab connector and the nozzle from the front fascia camera.
  6. Remove the screws (x2) from the camera, then remove the front fascia camera from the housing.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Phillips #1 screwdriver

Install

  1. Install the front fascia camera into the housing and install the screws (x2).
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Phillips #1 screwdriver
    2 Nm (1.5 lbs-ft)
  2. Connect the locking tab connector and the nozzle to the front fascia camera.
    Informational PurposesAn informational icon, calling your attention
    Note
    1x locking tab connector, 1x nano nozzle
  3. Install the front fascia camera cover and install the screws (x2).
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    4 Nm (2.9 lbs-ft)
  4. Unlock the vehicle gateway. See Gateway (Unlock).
  5. Run ODIN routine PROC_DAS_X_CLEAR-CALIBRATIONvia Service Mode:
    • Driver Assist ➜ Cameras ➜ Clear Camera Calibration
    • Driver Assist ➜ Driverless ➜ Clear Calibration
    via Toolbox:(link)
  6. Run ODIN routine PROC_DAS_X_UPDATE-CAMERAvia Service Mode:Driver Assist ➜ Cameras ➜ Update Cameravia Toolbox:(link)
  7. Run ODIN routine PROC_ICE_X_EXIT-SERVICE-MODEvia Toolbox:(link)
  8. Raise the LH front window.
  9. Close the LH front door.